Preowned Equipment

For Information regarding our preowned equipment inventory, contact Chip Nelson, Director of Sales and Marketing: 405.880.3647

2014 SIMCO 7000

IMG_4870 (Large).JPEG

IMG_4875 (Large).JPEG

IMG_4882 (Large) (1).JPEG

IMG_4874 (Large).JPEG

IMG_4876 (Large).JPEG

IMG_4877 (Large).JPEG

IMG_4886 (Large).JPEG

IMG_4907 (Large).JPEG

IMG_4897 (Large).JPEG

IMG_4893 (Large).JPEG

IMG_4889 (Large).JPEG

IMG_4871 (Large).JPEG

IMG_4919 (Large).JPEG

IMG_4868 (Large).JPEG

IMG_4908 (Large).JPEG

2014 Simco 7000

Sn: 142310

Hours = 10,294

Mileage = 177,709

Compressor = 319

29,500 Lbs Pullback, 15,000 Lbs Pulldown

Main Winch 18,000 Lbs

Auxillary Winch 3,800 lbs (might be an 8,000lb ugraded)

24ft of head stroke

300cfm/200psi Boss Air compressor

4x3x13 Centrifugal Mud Pump

5-1/2 x 8 Gardener Denver Piston Mud Pump

Kilgore, TX

Available November

Recent Repairs: PTO replaced. Center with new case and sides rebuild cases. New Swivel and new main winch line.

2012 GEFCO 30K

Larson 1.jpg

Larson 2.jpg

Larson 3.jpg

Larson 4.jpg

Larson 6.jpg

30K mounted on a 6x4 Peterbilt 357 powered by Cummins, 550hp, 22,000lb front axle, 46,000 rear tandem, 18 Speed Fuller Transmission.

425/65R22.5 front tires, 11R22.5 rear tires.

Rig is set up to handle 3-1/2” x 20’ Flush Joint drill pipe with 2-3/8” IF tool joint.

25,000lb Pull Down with 30,000 Hold Back, 1000cfm, 350psi Sullair compressor, 18gpm Bean Water Injection, and 7-gallon electric down hole lubricator.

25,000lb Single line hydraulic Main winch over the Jib, Hydraulic Rod Spinner, and Modified 60” Break Out Wrench, pulled by Hydraulic cylinder.

TopHead rated at 0-120rpm with infinite speed control, and 70,000inch lbs. torque.

24pc Rod storage rack with slide mounted on off driller’s side, and 6pc Carousel pipe not included.

Two (2) 100-gallon fuel tanks.